Boost Tracer Manuel d'instructions télécharger pdf (Page 12)

The Tracer can accept 12V, 24V nominal off-grid solar module arrays. Grid –tie

solar module(s) may be used if the open circuit voltage does not exceed the maximum

solar input rating. The solar module(s) nominal voltage must be equal to or greater

than the nominal battery voltage.

Figure3-3 Solar Module wiring

Step 4: Accessories (option)

Install Remote Meter (purchased separately) if required. Refer to the instructions

provided for detailed installation procedures.

Step 5: Confirm Wiring

Double-check the wiring in step1 through 4. Confirm correct polarity at each

connection. Verify that all six power terminals are tightened.

Step 6: Confirm Power-up

When battery power is applied and the Tracer powers up, the battery led indicator

will be green.

If the Tracer does not power up or battery status LEDs error exists, refer to

Section 5 Troubleshooting

Solar Module

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Pas de commentaire

Boost Tracer Manuel d'instructions Page 12